No you don't. You didn't comply.

Extremely recently?

From what I understand, he tried the same at Cottonwood Mall, as well.

First, it is one of only two major city centers in the state, much like most of the west. Your point?

Fashion Place has been renovated inside, and out, so no...I call bullshit on you living in Utah. Valley Fair is completing its renovation, so again, you're full of shit. Cottonwood is long since closed and awaiting rebuild, so again, you're full of shit.

• LDS leaders are often involved in ribbon-cutting ceremonies.

A - You're a dipshit. That was a selection of four different malls.
B - You're full of shit. At least 90% of malls are aged beyond a decade and most are decaying to the point where they have, or will be closing their doors.
C - The average American MSA has about 1-3 malls, most not able to support premium retail…

I agree x100!! Princess ships seem to be built to offend the senses!

Have you ever been to Utah??

I see you're the only other person in here who took physics.

Agreed.

Aside from the obvious assault and loss of medical licenses for performing a procedure the patient did not agree to, the doctors and staff will likely suffer penalties for multiple penalties of the hospital's Patient Bill of Rights: http://www.grmc.org/documents/Pati…

Was moving to Cali, driver fell asleep with cruise set, I woke up to bump strips and grabbed the wheel. Driver woke up as I was getting us back on the road, took the wheel and ripped it to the right causing us to bear down on the front-left, flipping the jeep and causing successive high speed rolls.

You might not have been rolling long enough for the adrenaline to kick in. When it's a few rolls, most people I know just remember banging around for a short while then being dazed, then amped from the adrenaline rush.

Speaking as someone who has lived to tell the tales of a high speed rollover, I still feel bad for these people.

Would it not be "Audio Apparati?"

You think wrong. Other vehicles in that segment from a wide variety of manufacturers were suffering greatly due to low quality/reliability ratings.

So how exactly is the G6 a pile of shit? I'd looooooove to see you quantify that, given that the G6 had consistently high reliability ratings.

I was pissed when I first saw this, but relieved and happy when I saw that other commenters have come out in force to defend the G6.

Isn't this a little unfairly suggestive?