OMC had horizontal stack rotary outboard motors 40 years ago! 

If you want to make yourself relatable to enthusiasts, cut out the buzzwords. That stuff looks great on a PowerPoint slide, but leaves a greasy film of distrust in a forum.

Bullshit.  The only thing that happens then, is Miguel becomes Rajib in Hyderabad.

Max Millar was the master of aircraft cutaway drawings. Flight Magazine from the 30's to 70's is iconic.

Had a’98

I had an ‘85 GT also. When my wife wanted to knit me a sweater, I had her do it in grey with red piping like the seats in mine.

Iwas able to rescue a Beetle with the tip of a ziptie. The points were worn down to no gap, so a Swiss army knife was enough to shine them up and the ziptie set the gap. Pushed it , dumped the clutch , and away it went.

I’ve found a quick light wipe of acetone gets that brown, powdered layer off. Saves a ton of work!

Evaporated milk +corn starch is a common diet tweak for thickening sauces, but it’s not as good (of course!)

Good, but John Bonham is what put it over the top

Most ventanitas have grinders

I replaced a 2011 LaCrosse with one.

I’m currently at 178k with mine..

It’s a drag racing engine , so no water jackets to complicate things.

Ford GAA tank engine was shaft and spur gears also.

Get a rebuild kit. Easy and cheap.

Bubba Wallace seems to be it.

Sounds like a successor to my Speed3

Strongly reminiscent of the 911

Hand assembly is not the issue here. Hand assembly without proper fixtures and tooling is. If there’s a procedure and fixtures to do the job, this wouldn’t happen.