Late 90's I drove my girlfriends mid-90's Ford Explorer. Not sure if it had shocks on it. It was the body roll. I stood in the middle of see-saws that felt more laterally stable. It wanted to roll over.

1974 Trans-Am. Done. 1974 corvette? 

Jalopnik - no longer news/media sight? This ‘article’ seems more suitable to a reddit post..

Snap! I live in Fayetteville. Make almost weekly trips there. Due to AR laws only Sams in the state that sells liquor, and their prices are good. 

Big difference between ASK a $110k and actually selling for $110k..

You can pick up a really nice C5 Corvette for this kind of money. 

2003-05 Lincoln LS - at least for the fog light cover. Right Hand corner.

I believe they are required by law, at least in the US. 

Gen 2 - CTS-V Sportwagon.

This show like Battle bots will be better to watch on youtube. Cut out all the b/s and get right to the 2-3 minutes of actual content. 

Nissan... release the IDx. It would be a new car to your aging line up, and it would be sweet. Be a hit as long as they didn’t dumb it down too much for production or charge way too much. I think it could be a company saver.

I’m a sucker for a deal. I ran into a great deal on a used 2011 Prius. As much as I want to hate it... It’s a pretty dang good car. 42 mpg in eco - even when I drive it hard. It is relatively quick in power mode (no, really it is). Has lots of room with the rear seats down. Comfortable, quiet, good mpg, storage room,…

If they did they would roll out a $10M marketing plan with it.. and then charge $18,000.00 -bare bones. Oh, you want the orange and white paint of the old one? $2000 nostalgia package.

I feel he has been renamed. Whether he likes it or not. 

Even in the picture it’s dripping coolant from it’s blown head gasket...waaawaaawaa

Why not push it into a lake, or pond? Guess you have to worry about contamination at that point..

I would have some uhh, spacers under it to hold it off angle. Not that it would work but it would make me feel like I was sticking it to the man. (live in Arkansas, not front plate here). 

https://buffalo.craigslist.org/cto/d/jamesville-1965-dodge-dart/6813684920.html   Umm.. Has the workings for be a lot of fun for $2k.

Next record. Fastest J-turn. 

That and it’s 32 valve motor is an interference motor. Valves run $100+ each at cost. Want to go ahead and lift the body off the motor and change the timing belt? Belt is cheap, idler pulley is only that you really need to replace while you are in there...$1k at cost. +water pump, +labor.