Still part of Big Screw

It would be a good Jalopnik story. Its really to long and involved though. I had a lot of it document here when we could do a side blog for free. That is long gone though.

If this had a Reserve you would have a point.

What about all of the Russian Airline problems? Not including the military stuff that is getting shot down by the Ukrainians

Its the combo Sponsor and MFG that is the problem

Reasonable until you strip it when you need it

Team Names like this are fine. They are the team name or in the case of Andrea Moda and Benetton owned by the sponsor.

I can’t think of one. 

Looking at their Screwdriver rig they do have a Machinist on staff. That has all the blocky look of carve it out of billet with a manual machine. Complete with some Allen Head screws which machinists love. 

Drove my 5 Series wagon back from a work event late at night and was doing 50 in heavy snow that had not been plowed. Traction control would just randomly flicker on. Back end was lightly moving. Not typical but their is always lots of crap out on the roads that people are hitting. 

Hope they tested them in the snow. I give them 1-2 years before they are corroded and don’t work or have been ripped off

There is a reason you don’t make screwdriver bits out of Stainless. Subject to galling and easy to strip.

Database Administrator has been fired. Beatings will continue until morale improves

Why would I troll you?

Lived the whole crappy German plastic on my E39 and to a lesser extent on my 850 which had lots of different problems

Thanks for  the reminder, I am going to put some zip ties in my bibs

I was going to get a Cube when Cash for Clunkers was going on. My Geo Metro 40 MPG did not qualify and the POS Dodge was not that bad then. So I waited and got a used Scion xB

Likely but it worked with the previous set for a number of years so I am going with I did not any on the first time and trusted the factory dab would work. I would safety wire them if I could but no room

No Swirls

No It was not. Wet sand with 400 grit and rattle can 2X Clear. Lots of buffing and it came out kinda Satin