Still, 20% of them being ready in less than 30 min sounds a wee bit optimistic.

Cut their dicks off, and feed their testicles to some pigs. And fuck these 2 assholes specifically. With a couple of rusty rods.

Dissonance, not dissidence.

You want to use something that is ecologically retrograde, then that’s your concern, but it’s too expensive and wasteful to keep plastic straws on hand for the .1% of the population that actually need one. Learn to pack a straw.

Ten Things was awesome, never caught Josie though, maybe it’s time for a Noughties movie marathon...

And anything with a bit of mass will punch right through your "curtain", likely causing damage.

Without the windshield, that front end looks like ass with the deflector deployed. Easier to just wear a helmet.

Even the tires? Rubber gets hard after a few years...

Fair enough.

Easier to buy an Ariel Atom or Caterham and avoid looking like a twat with too much money altogether.

You'd rather have a fine mist of toilet water on your toothbrush?

It’s a 2 inch curb. How in the fuck did these jackasses trip on a fucking 2 inch curb?

Then they need to figure out how to talk English, because that setup is not a hub motor, it would likely best be described as independent drivetrains, similar to independent suspension.

Sorry honky, you're done here.

Tomorrow will be a brighter morning because you’re still in this world. And if you’re going through Hell, don’t stop until you’re out the other side.

I know I didn’t get what I thought I wanted, I got what I didn't know I needed, time with my nieces and cousins celebrating Christmas. And I appreciate your making mention of what people think they want, most people haven't a clue what they actually want or need.

You guys missed an opportunity to spell out a naughty word with the decor...

Not likely, they still need to pack a ton of batteries between the frame rails, and driveshafts are generally inboard of the suspension linkages. Honestly though, unless Rivian has engineered a super lightweight integrated wheel and motor, I doubt it will be a direct hub motor application. More than likely, it will be…

I'm thinking the motors might be inboard with a short driveshaft. As long as the motor is bolted to the chassis and not the actual wheel, unsprung mass shouldn't be a problem.

And since they’re supposed to be hub motors, no driveshafts that'll shatter.