$14k to enjoy wheel-hop and fight torque-steer? No thanks.
That doesn’t look like a trailer park to me, more like a storage facility where some trailers happened to be stored in the bg.
I’d usually agree; people buy Jeeps because of certain things Jeeps do that make them less suitable for DD’ing and you need to accept that when buying one. The problem is that the previous model didn’t roll over in the same crash scenario and FCA tested this one and said it isn’t supposed to flip in this crash…
Internet toughguy is a bad look, especially when you generously frost that shit cake with ignorance and racism.
Just for the uninitiated: Wrap your wrench handle in something insulating before you start. Or better yet, buy this only slightly more expensive set with the rubber “cushion” grips. This will help prevent the unlikely event of you getting shocked, and the very likely event of you shorting the battery to itself or the…
Just for the uninitiated: Wrap your wrench handle in something insulating before you start. Or better yet, buy this…
You’re inhuman if this doesn’t hit you where it hurts to read: “I shouldn’t have to bury my little brother.”
All great advice for non-Jalopniks.
All great advice for non-Jalopniks.
Is that an olive green Dodge Journey it’s sitting atop? If so, maybe we can line this with some silver by labeling it a mercy killing?
It’s a menace.
So... you’re saying we shouldn’t bother to jump start it, then?
So... you’re saying we shouldn’t bother to jump start it, then?
I’ve owned and used a Clore JNC660 for 6.5 years now (still have it) that I got on sale for $100. So far, it’s performed flawlessly for me with little to no maintenance even though it’s been stored in an unheated/uncooled garage in New England that whole time.
I’ve owned and used a Clore JNC660 for 6.5 years now (still have it) that I got on sale for $100. So far, it’s…
I completely agree, just wanted to make sure anyone buying was aware of what they were getting as the article title makes it seem like these are drills when they aren’t.
I completely agree, just wanted to make sure anyone buying was aware of what they were getting as the article title …
Buyers should keep in mind that as compact, and well priced as these are they aren’t real drills, they’re bit drivers. They require special drill bits to actually drill holes because they have a hex adapter, not a typical 3 jaw chuck. The drill bits for these cost about twice as much as regular bits and are harder to…
Buyers should keep in mind that as compact, and well priced as these are they aren’t real drills, they’re bit…
Yes they do; or at least they absolutely can, anyway. Unfortunately that doesn’t make my OP any less valid because with the cheaper gas prices EV sales are going to likely suffer.
Unfortunately the cheap gas will probably only end up sparking another resurgence in brick-shaped vehicle sales. If we could come out of this moving more towards the Euro mindset where efficiency and fun seem to rank towards the top of their priority lists, I’d be much happier.
Sure, but it still wouldn’t be worth that asking price if you went with one of those engines. The LS swap immediately gains it a cult following amongst the fanbois which one of would snatch up at that price.
I hate LS swaps because of how common they are (and the fanboi following doesn’t help), but this thing needs an LS swap immediately. Then it’d be worth the asking price.
I think he’s hoping that by admitting to this relatively minor offense it gives him some credibility to call BS on any more serious allegations that may spring up.
It’s been a few years, you should definitely revisit this as not only is this particular NUC not available anymore, a lot of people are stuck at home and itching to do shit and probably want to watch shit too.
It’s been a few years, you should definitely revisit this as not only is this particular NUC not available anymore,…